FAQ about emergency shower & eyewash
Question: What water temperature is required?
Answer: The ANSI standard recommends that the water should be “tepid”. The
ANSI 358.1-2004 appendix defines tepid waster as water temperature
between 60° F – 100° F ( 16 ° C-38 ° C ).
In locations where freezing temperatures exist, frost-proof or freeze protected
equipment must be installed.
In locations where temperatures reach scalding levels from heat or exposure
to direct sunlight, scald protection valves must be installed.
Question: What are examples of areas that may require eyewash stations?
Answer: Work areas and operations that may require these devices include:
• Battery charging areas
• Laboratories
• Spraying operations
• High dust areas
• Hazardous substances dispensing stations
• Marine shipping vessels & offshore platform
• oil, gas, chemical, petrochemical area and so on
Question: Do I really need to test (activate) plumbed eyewashes weekly?
Answer: Yes, testing of plumbed units is required to ensure a flushing fluid supply is available when needed. Flushing helps clear the supply line of any sediment buildup and minimizes microbial contamination due to sitting water.
A comprehensive inspection should be conducted at least once a week to verify the reliability and effectiveness of the device, ensure effective emergency use in the event of an accident, and provide reliable personal safety and health protection.
Warning: Emergency use is only allowed in the event of an accident. Cleaning and use are strictly prohibited in daily life. Regulations and inspections should be established to prevent violations or frequent use of hand washing tools, which may cause product malfunction and unexpected accidents.
Question: How often do I need to clean and maintain my portable self-contained eyewash?
Answer: Portable eyewashes that mix potable water and preservative should be cleaned and refilled per the manufacturer's instructions, which typically is every four to six months.
Answer: The ANSI standard recommends that the water should be “tepid”. The
ANSI 358.1-2004 appendix defines tepid waster as water temperature
between 60° F – 100° F ( 16 ° C-38 ° C ).
In locations where freezing temperatures exist, frost-proof or freeze protected
equipment must be installed.
In locations where temperatures reach scalding levels from heat or exposure
to direct sunlight, scald protection valves must be installed.
Question: What are examples of areas that may require eyewash stations?
Answer: Work areas and operations that may require these devices include:
• Battery charging areas
• Laboratories
• Spraying operations
• High dust areas
• Hazardous substances dispensing stations
• Marine shipping vessels & offshore platform
• oil, gas, chemical, petrochemical area and so on
Question: Do I really need to test (activate) plumbed eyewashes weekly?
Answer: Yes, testing of plumbed units is required to ensure a flushing fluid supply is available when needed. Flushing helps clear the supply line of any sediment buildup and minimizes microbial contamination due to sitting water.
A comprehensive inspection should be conducted at least once a week to verify the reliability and effectiveness of the device, ensure effective emergency use in the event of an accident, and provide reliable personal safety and health protection.
Warning: Emergency use is only allowed in the event of an accident. Cleaning and use are strictly prohibited in daily life. Regulations and inspections should be established to prevent violations or frequent use of hand washing tools, which may cause product malfunction and unexpected accidents.
Question: How often do I need to clean and maintain my portable self-contained eyewash?
Answer: Portable eyewashes that mix potable water and preservative should be cleaned and refilled per the manufacturer's instructions, which typically is every four to six months.